Arctic Cat PANTERA 7000 2015, Руководство оператора

Страница: 34 / 64

30
XM125A
4. Using Oil Filter Wrench (p/n 0644-
551), loosen (but do not remove) the
oil filter and allow the oil to drain
from the filter into the drain pan;
then remove the filter.
5. Apply a light coat of fresh engine oil
to the seal of the new oil filter.
6. Install the new oil filter by turning
the oil filter by hand until the seal
has contacted the oil filter mounting
surface; then tighten the oil filter to
12 ft-lb. Remove the drain pan.
7. Install the engine oil drain plug with
a new gasket; then tighten to 7.2 ft-
lb.
8. Remove the four torx-head screws
securing the right-side footrest to the
tunnel and the support; then with a
drain pan in position, remove the
drain plug from the oil tank.
746-121A

NOTE: To aid in draining the oil
from the oil tank, position a funnel
between the tank and the opening of
the tunnel running board.
9. After the oil has drained completely,
install the drain plug with a new O-
ring and tighten to 16 ft-lb.
10. Pour the recommended engine oil
into the oil tank.
11. Without starting the engine, place
the handlebar emergency stop
switch to the RUN position and the
ignition switch to the ON position.

NOTE: If the warning icon does not
illuminate, take the snowmobile to
an authorized Arctic Cat Snowmo-
bile dealer for service. If not under
warranty, this service is at the dis-
cretion and expense of the snowmo-
bile owner.
12. If the warning icon illuminates (from
step 11), start the engine. The warning
icon should go out within five seconds.
If it does, proceed to step 13.

NOTE: The engine may need to be
started 2-3 times before it will stay
running.

NOTE: If the warning icon does not
go out, shut the engine off immedi-
ately and repeat step 11; then place
the ignition switch to the ON posi-
tion and repeat step 12. If the warn-
ing icon does not go out, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer for service. If
not under warranty, this service is at
the discretion and expense of the
snowmobile owner.
13. Shut the engine off; then add oil to
the oil tank until oil is visible half-
way up in the sight glass.

NOTE: If the oil and engine are not
at operating temperature, the oil
level may read too low. Always make
sure the engine is at operating tem-
perature before checking the oil.
14. Install the access plate and torx-head
screws beneath the snowmobile; then
install the hood and access panels.
Coolant Level
ZR 4000

NOTE: Use a good quality, ethyl-
ene glycol-based, automotive-type
coolant.

NOTE: Always check the coolant
level with the engine cold.