Arctic Cat PANTERA 7000 2015, Руководство оператора

Страница: 32 / 64

28
The longevity and safety of the snowmo-
bile can be increased by making periodic
checks of the items in the preceding
checklist.
If, at any time, abnormal noises, vibra-
tions, or improper working conditions of
any component of this snowmobile are
detected, DO NOT OPERATE THE
SNOWMOBILE. Take the snowmobile
to an authorized Arctic Cat Snowmobile
dealer for inspection and adjustment or
repair. If not under warranty, this service
is at the discretion and expense of the
snowmobile owner.
The snowmobile should be taken to an
authorized Arctic Cat Snowmobile dealer
at the end of each snowmobiling season
for general inspection and for off-season
storage servicing. This inspection and
servicing is at the expense of the snow-
mobile owner.
Fuel System
In-Line Fuel Filter (Pantera
7000)
Arctic Cat recommends that the in-line
fuel filter be replaced every 5000 miles.
The in-line fuel filter is located under the
upper console. The filter must be clean to
allow the fuel hose to transmit the
amount of gasoline required.
If the in-line fuel filter is obstructed, gas-
oline flow will be restricted; therefore,
the filter must be replaced. To remove
and install the in-line fuel filter, use the
following procedure:

NOTE: Before removing the fuel fil-
ter, take note of the filter inlet and
outlet for installing purposes.

NOTE: The fuel filter is located on top
of the fuel tank. To access the filter, the
access panels, hood, seat, and con-
soles need to be removed.
XM268
1. Remove the fuel filter from the fuel
filter bracket.
2. Remove the existing hose clamps
and discard; then slowly remove the
fuel hoses from the fuel filter. Dis-
pose of the excess fuel from the fil-
ter properly.
3. Inspect the fuel hoses thoroughly for
any signs of cracking, cuts, or wear
points.
4. Place new hose clamps on the
gasline hoses; then press the hoses
fully onto the fuel filter making sure
the inlet and outlet oriented cor-
rectly. Secure the new hose clamps
using Fuel Hose Clamp Tool (p/n
0644-545).
5. Secure the new fuel filter to the fuel
filter bracket; then start the engine
and inspect the fuel hoses and filter
for any signs of leaks.
0746-802
! WARNING
Whenever any maintenance or
inspection is made on the fuel system
in which there may be fuel leakage,
there should be no welding, smoking,
open flames, etc., in the area.
! WARNING
Since the fuel supply hose may be
under pressure, always wear safety
glasses; then remove the hose slowly
to release the pressure. Place an
absorbent towel around the connec-
tion to absorb the fuel.