Arctic Cat BEARCAT 2015, Руководство оператора

Страница: 52 / 68

48
0744-462
1. Disconnect the taillight harness con-
nector.
2. Remove the two self-tapping screws
securing the taillight to the snowflap.
3. Secure the taillight to the snowflap
with the two self-tapping screws;
then connect the taillight connector.
4. Secure the front of the snowflap to
the tunnel by carefully tapping the
snowflap until the two flanged tabs
snap into place.
Removing and Installing
Taillight/Brakelight
(Bearcat XT)
1. Remove the four pins securing the
rear seat to the seat/Speedrack mount.
743-329A

NOTE: On the LTD, also remove
the two pins securing the third seat
to the seat/Speedrack mount; then
lift the third seat up and away.
0745-131
2. Lift on the back of the rear seat and
move rearward to remove it from the
mount.
3. Compress the latch on the right side
of the front seat and lift the front seat
away; then disconnect the taillight
harness connector.
743-444A
4. Loosen (but do not remove) the
three right-side seat/Speedrack
mount cap screws.
5. Carefully route the harness connec-
tor through the hole in the storage
compartment panel; then remove the
harness from beneath the seat/Spee-
drack mount.
6. Remove the two self-tapping screws
securing the taillight to the bumper;
then route the harness out of the
bumper and remove the taillight.
7. Route the taillight harness through
the bumper; then secure the taillight
to the bumper with the two self-tap-
ping screws.
8. Carefully route the harness beneath the
Speedrack mount and through the hole
in the storage compartment panel; then
connect the harness connector.
9. Tighten the three right-side mount
cap screws; then lower the front seat.
10. Place the rear seat into position on
the mount making sure the four pin
holes are properly aligned with the
mounting location on the mount.
11. Install the four pins making sure
they are properly seated.