Arctic Cat BEARCAT 2015, Руководство оператора

Страница: 14 / 68

10
With RPM displayed on the readout
screen by pushing and holding the incre-
ment button, maximum RPM will be dis-
played on the readout screen. The
maximum RPM readout will reset when
the decrement button is pushed (while
maximum RPM is displayed).
Odometer/Trip-Meter (1)/
Trip-Meter (2)/Hour-Meter
By pushing the decrement button, the
readout screen will display odometer,
trip-meter (1), trip-meter (2), and hour-
meter. To reset the trip meter with the trip
meter displayed, push and hold the decre-
ment button until the display is cleared.
The hour-meter readout will not reset.
Clock/Altimeter
By pushing the select button, the readout
screen will display clock, altimeter, and
maximum altimeter.
To set the clock, select clock on the dis-
play by pushing and holding the select
button for two seconds; the option of
selecting the 12-hour or 24-hour clock
mode is available. Push the increment
button to toggle between the 12-hour dis-
play and the 24-hour display. When
desired mode is displayed, push the
select button.
At this point, the hours display will begin
to flash. Push the increment button to
increase the hours; push the decrement
button to decrease the hours. Pushing and
holding a button will accelerate the num-
ber display. When desired hour number is
displayed, push the select button.
At this point, the minutes display will
begin to flash. Push the increment button
to increase the minutes; push the decre-
ment button to decrease the minutes.
Pushing and holding a button will accel-
erate the number display. When desired
minute number is displayed, push the
select button.

NOTE: During clock setting if no
button (increment, decrement,
select) is pushed within a 5-second
time period, the clock-setting mode
will be exited with changes saved.

NOTE: The altimeter readout is
based off barometric pressure and
may require calibration as weather
conditions change.
To set/calibrate the altimeter to an estab-
lished altitude with altimeter selected on
the display screen by pushing and hold-
ing the select button for a minimum of
two seconds, the acronym CAL will be
displayed on the readout screen for one
second; then the altitude value will flash.
Push the increment button to increase the
displayed altitude; push the decrement
button to decrease the displayed altitude.
Pushing and holding a button will accel-
erate the number display.

NOTE: If MPH has been selected in
the speed readout, the altitude value
will be displayed in feet. If kph has
been selected in the speed readout,
the altitude value will be displayed in
meters.
To reset the maximum altimeter readout
with the maximum altimeter displayed,
push and hold the select button for a min-
imum of two seconds.
A. High Beam Indicator
The indicator is on whenever the high beam
mode is selected by the headlight switch.
B. Oil Pressure Warning
Icon (5000)
This icon indicates engine oil pressure,
not the oil level; however, if the oil level
is low, it may affect oil pressure.
The icon should illuminate each time the
ignition switch is turned to RUN or START,
and it should go out when the engine starts.
If the icon illuminates while the engine is
running, oil pressure has been lost and the
engine will automatically shut off.
If oil pressure is lost, check the oil level
(see page 30).
If the warning icon does not go out or if
the engine does not start, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.