56
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Adjust each headlight until correct
aim is obtained by turning the
adjuster clockwise to lower or coun-
terclockwise to raise the beam.
Fuses
The fuses are located in a
power distribution module
in front of the steering post
under the electrical access
panel. If there is any type of
electrical system failure,
always check the fuses first.
NOTE: To remove the
fuse, compress the locking tabs on either side of the fuse
cover and lift out.
Electrical Output Terminals
Two output terminals for electrical accessories are located on the front
and rear wiring harnesses. The accessory plug is located on the front
body panel.
Tools
A basic tool kit is provided with the ATV. Maintain the tool kit with
the ATV at all times. The tool kit is located under the seat.
KC0108A
2411-566
CAUTION
Always replace a blown fuse with a fuse of the same type and
rating. If the new fuse blows after a short period of use, con-
sult an authorized Arctic Cat ATV dealer immediately.
CAUTION
Always use electrical accessories less than 180W.
Содержание 450 XC 2011
Страница 66: ...64 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES...
Страница 69: ...67 NOTES...