Arctic Cat 450 XC 2011, Руководство оператора

Страница: 57 / 72

55
Light Bulb Replacement
The wattage rating of each bulb is shown in the chart. When replacing
a burned bulb, always use the same wattage rating.

NOTE: The bulb portion of the headlight is fragile. HANDLE
WITH CARE. When replacing the headlight bulb, do not touch
the glass portion of the bulb. If the glass is touched, it must
be cleaned with a dry cloth before installing. Skin oil residue
on the bulb will shorten the life of the bulb.
To replace the headlight bulb, use the following procedure.
1. Remove the wiring harness connector from the back of the headlight.
2. Grasp the bulb housing, turn it counterclockwise, and remove the bulb.
3. Install the new bulb into the housing and rotate it completely
clockwise.
4. Install the wiring harness connector.
To replace the taillight/brakelight bulb, use the following procedure.
1. Rotate the socket counterclockwise and remove it from the housing.
2. To remove the bulb from the socket, push in and rotate counter-
clockwise.
3. To install the bulb, push in and turn clockwise.
4. Insert the socket into the housing and rotate it clockwise.
Checking/Adjusting Headlight Aim
The headlights can be adjusted vertically
and horizontally. The geometric center of
the HIGH beam light zone is to be used
for vertical and horizontal aiming.
1. Position the ATV on a level floor so
the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).

NOTE: There should be an average operating load on the ATV
when adjusting the headlight aim.
2. Measure the distance from the floor to the mid-point of each
headlight.
3. Using the measurements obtained in step 2, make horizontal
marks on the aiming surface.
4. Make vertical marks which intersect the horizontal marks on the
aiming surface directly in front of the headlights.
5. Switch on the lights. Make sure the HIGH beam is on. DO NOT
USE LOW BEAM.
Headlight 12V/35W (4)
Taillight/Brakelight 12V/5W/21W
CAUTION
Use only specified bulbs indicated in the chart as replace-
ment bulbs.
CAUTION
When replacing the headlight bulb, be careful not to touch the
glass portion of the bulb. Grasp the new bulb with a clean cloth.
ATV-0070