Arctic Cat 450 XC 2011, Руководство оператора

Страница: 41 / 72

39
3. Tighten the jam nut securely.

NOTE: The ATV is equipped with an RPM limiter that
retards ignition timing when maximum RPM is approached.
When the RPM limiter is activated, it could be misinterpreted
as a high-speed misfire.
Speedometer/LCD (Digital)
1. Clock/Engine Hour Meter -
The clock function indicates
time in the 12-hour mode; the
hour meter indicates the total
time the ATV has run and
cannot be reset to zero. To set
the clock, use the following
procedure.
A. With the ignition switch
ON, press and release the
Set Button (4) until the Clock (1) is displayed; then press
and hold the Set Button (4) to activate the set mode (clock
display flashing).
B. Press and release the Set Button (4) to set minutes or the
Mode Button (3) to set hours. Holding the respective button
down will scroll the display.

NOTE: Clock memory power is supplied through the 15-amp
accessory fuse and verified during gauge “power-up” and
reset. In the event of clock memory power failure (blown fuse,
etc.), the gauge will “power-up,” reset, and shut down repeat-
edly until clock memory power is restored. Always check the
15-amp accessory fuse if this gauge condition is noted.

NOTE: The engine hour meter will not activate until engine
speed exceeds 500 RPM.
2. Temperature Indicator - If the engine coolant temperature exceeds the
normal operating range, the temperature icon will begin flashing and
the LCD will go blank for 30 seconds; then the LCD will return to nor-
mal. However, the temperature icon will continue to flash (see Liquid
Cooling System for more information).
3. Mode Button - Shifts the gauge through two operating modes:
speedometer/tachometer and MPH/KPH.

NOTE: The Mode Button must be pressed and released to
shift speedometer/tachometer modes. It must be pressed
and held to shift MPH/KPH modes.
4. Set Button - The Set Button is used to select the gauge display of
clock, hour meter, trip 1, trip 2, and odometer. It is also used to activate
the clock set function and adjust the minute display on the clock.
5. Fuel Level Indicator - Indicates approximate amount of gasoline
in the gas tank.

NOTE: When the bottom segment flashes, approximately
3.5 L (0.92 U.S. gal.) of gasoline remains in the tank.
6. Oil Pressure Indicator - Will be displayed during self-test at start-
up. It will not be displayed during normal operation as oil pres-
sure is not monitored on these models.
7. Odometer/Trip Meter - Odometer registers the total distance the
vehicle has traveled. The trip meter is resetable and can be used to
measure trip or trip legs. The odometer cannot be reset.
8. Gear Position Indicator - Indicates which gear is currently
selected - R (reverse)/N (neutral)/L (low range)/H (high range).
EFI-011A