190
3. Remove the nuts securing the gauge assembly to the
dash; then unplug the multi-pin connector and remove
the gauge from the vehicle.
4. Place the new gauge into the dash panel opening; then
place the gauge holder over the mounting screws and
secure with the nuts.
5. Plug the multi-pin connector into the gauge; then turn
the ignition switch to the ON position and check
gauge functions.
6. Install the dash and secure with the four screws; then
install the hood and grille (see Hood in this section).
Exhaust System
REMOVING MUFFLER
1. Remove the four exhaust springs at the muffler/
exhaust pipe juncture.
WC153A
2. Slide the muffler assembly clear of the holder pins.
INSPECTING MUFFLER
1. Inspect muffler externally for cracks, holes, and dents.
2. Inspect the muffler internally by shaking the muffler
back and forth and listening for rattles or loose debris
inside the muffler.
NOTE: For additional details on cleaning the muffler/
spark arrester, see Periodic Maintenance/Tune-Up.
INSTALLING MUFFLER
1. Place the muffler onto the holder pins and slide into
position.
2. Secure the muffler to the exhaust pipe with the two
exhaust springs.
Cargo Box
REMOVING
1. Remove the rear body panel (see Rear Body Panel in
this section).
2. Remove the four fender screws securing the cargo box
to the mounts and remove the cargo box.
WC345A
INSTALLING
1. Set the cargo box into position on the cargo box
mounts; then secure with the four fender screws.
Tighten securely.
2. Install the rear body panel (see Rear Body Panel in
this section).
Seats
REMOVING/INSTALLING
1. To remove a seat, pull the seat lock lever up. Raise the
rear of the seat and tilt it forward.
WC017A
2. To install a seat, slide the front of the seat into the seat
retainers and push down firmly on the rear of seat. The
seat should automatically lock into position.