50
OFF
position — All electrical circuits
except the accessory plug are off. The
engine will not start. The key can be
removed in this position.
NOTE: The accessory plug is
powered by the battery at all times.
ON
position — The ignition circuit is
complete and the engine can run. The key
cannot be removed in this position.
LIGHTS
position — The ignition circuit is
complete and headlights and taillight are on.
The key cannot be removed in this position.
NOTE: Leaving the ignition
switch in the ON or LIGHTS posi-
tion for a long period of time when
the engine is not running may
cause the battery to discharge.
Always leave the ignition switch in
the OFF position when engine is
not running.
Shift Lever (400/500/550)
This ATV has a dual-range automatic
transmission with reverse.
Shift Lever (700/1000)
This ATV has a dual-range automatic
transmission with reverse and park.
Drive Select Switch
FI475A
KC342
This switch allows the operator to operate
the ATV in either 2-wheel drive (rear
wheels) or 4-wheel drive (all wheels). For
normal riding on flat, dry, hard surfaces,
2-wheel drive should be sufficient. In situ-
ations of aggressive trail conditions, 4-
wheel drive would be the desired choice.
To either engage or disengage the front
wheels, move the switch to the 4WD posi-
tion or to the 2WD position.
On the 550/700/1000, the 4WD lock
allows the operator to mechanically lock
the front differential to apply equal
power to both front wheels. To engage
the lock from 4WD, slide the switch up
and move it fully to the left. To disengage
the lock, move the switch lever to the
right.
Handwarmers/
Thumbwarmer (Limited)
The operator’s handwarmers/thumb-
warmer are controlled by a rocker-type
switch on the instrument pod. There are
three positions on the switch (Low/Off/
High).
550/700/1000
400/500
CAUTION
Do not attempt to either engage or
disengage the 4WD lock while the
ATV is moving.
! WARNING
The 4WD lock is intended for use
where minimum traction is available.
NEVER EXCEED 10 MPH (16 kph)
with the lock engaged. Maneuverabil-
ity and handling characteristics will
differ with the lock engaged. ALWAYS
shift into four-wheel drive prior to
engaging the front differential lock.
Failure to follow this procedure may
result in loss of control. Control loss
can result in severe injury or even
death.
Содержание 2013 1000 TRV
Страница 89: ...87 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES ...
Страница 90: ...88 NOTES ...