36
Adjusting Skid Frame Rear
Arm Shock Spring
Proper adjustment of rear arm shock
absorber spring pre-load is necessary to
get the most desirable ride.
The rear arm shock spring is adjustable
for the terrain conditions and driving
style and weight of the operator. The
spring adjuster nut has been set at the fac-
tory so the correct amount of threads are
exposed between the adjuster nut and the
threaded shock body as an initial setting.
Rear spring pre-load adjustment is
accomplished by loosening the adjuster
nut locking collar (B) from the adjuster
nut (A) and using the Spring Adjuster
Tool from the tool kit, rotating the
adjuster nut in whichever direction is
desired. Tighten the locking collar
against the adjuster nut.
0745-159
Lights
For the correct headlight bulb and/or tail-
light/brakelight LED, see the appropriate
specifications sheet.
Removing and Installing
Taillight/Brakelight
These models are equipped with an LED
taillight/brakelight. If the LED fails, it
must be replaced. To remove and install
the LED, use the following procedure.
NOTE: To access the harness con-
nector and the two self-tapping
screws securing the taillight to the
snowflap, compress the two flanged
tabs (located on the under-side of
the tunnel) and carefully pry up on
the front of the taillight/snowflap.
0744-462
1. Disconnect the taillight harness con-
nector.
2. Remove the two self-tapping screws
securing the taillight to the snowflap.
3. Secure the taillight to the snowflap
with the two self-tapping screws;
then connect the taillight connector.
4. Secure the front of the snowflap to
the tunnel by carefully tapping the
snowflap until the two flanged tabs
snap into place.
Removing Headlight Bulb
NOTE: The bulb portion of headlight
is fragile. HANDLE WITH CARE. When
replacing the headlight bulb, the bulb
assembly must first be removed from
the housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a dry
cloth before installing.
To access the headlight bulbs, use the fol-
lowing procedure:
1. With the hood closed, loosen the
headlight adjustment knobs.
2. Carefully push the headlight lenses
rearward far enough to remove the
torx-head screws securing the air
silencer plenum to the hood.
3. Open the hood; then remove the O-
rings securing the air silencer ple-
num to the hood and remove the air
silencer plenum to access the bulbs.
! WARNING
Do not adjust the front arm limiter
straps to a point at which steering
and operator control of the snowmo-
bile are adversely affected.