Arcteq AQ-S254, Инструкция по эксплуатации

Страница: 52 / 106

Event block name Event names
OBJ10 Close Request OFF
OBJ10 Close Command ON
OBJ10 Close Command OFF
OBJ10 Open Blocked ON
OBJ10 Open Blocked OFF
OBJ10 Close Blocked ON
OBJ10 Close Blocked OFF
OBJ10 Object Ready
OBJ10 Object Not Ready
OBJ10 Sync Ok
OBJ10 Sync Not Ok
OBJ10 Open Command Fail
OBJ10 Close Command Fail
OBJ10 Final trip ON
OBJ10 Final trip OFF
Table. 5.2.2 - 14. Register content.
Name Description
Date and time dd.mm.yyyy hh:mm:ss.mss
Event Event name
Recorded Object opening
time
Time difference between the object receiving an "Open" command and the object receiving the
"Open" status.
Recorded Object closing
time
Time difference between the object receiving a "Close" command and object receiving the
"Closed" status.
Object status The status of the object.
WD status The status of the withdrawable circuit breaker.
Open fail The cause of an "Open" command's failure.
Close fail The cause of a "Close" command's failure.
Open command The source of an "Open" command.
Close command The source of an "Open" command.
General status The general status of the function.
5.2.3 Indicator object monitoring
The indicator object monitoring function takes care of the status monitoring of disconnectors. The
function's sole purpose is indication and does not therefore have any control functionality. To control
circuit breakers and/or disconnectors, please use the Object control and monitoring function. The
monitoring is based on the statuses of the configured relay's digital inputs. The number of monitored
indicators in a relay depends on the device type and available inputs. The status monitoring of one
monitored object usually requires two (2) digital inputs. Alternatively, object status monitoring can be
performed with a single digital input: the input's active state and its zero state (switched to 1 with a
NOT gate in the Logic editor).
A AQ Q-S254 -S254
Instruction manual
Version: 2.06
50 © Arcteq Relays Ltd
IM00024