Safety instructions
5/39EN
Refrigerator / User Guide
•
The more refrigerant a refrigerator
contains, the larger the installation
location must be. If the installation
location is too small, flammable
refrigerant and air mixture will
accumulate in cases of refrigerant
leakage in cooling system. The required
space for each 8 gr of refrigerant
is 1 m
³
minimum. The amount of
refrigerant in your product is indicated
on the Type Label.
•
Product must not be installed in
places exposed to direct sunlight
and it must be kept away from heat
sources such as hobs, radiators, etc.
If it is inevitable to install the product
close to a heat source, a suitable
insulation plate must be used in between
and the following minimum distances
must be kept to the heat source:
- Minimum 30 cm away from heat
sources such as hobs, ovens, heater units
or stoves,
- Minimum 5 cm away from electric
ovens.
•
Protection class of your product is
Type I. Plug the product in a grounded
socket that conforms the voltage,
current and frequency values stated
on the type label of the product. The
socket must be equipped with a 10
A – 16 A circuit breaker. Our company
shall not be liable for any damages
that will arise when the product is
used without grounding and electrical
connection in accordance with the
local and national regulations.
•
Product must not be plugged in during
installation. Otherwise, there is the
risk of electric shock and injury!
•
Do not plug the product in sockets
that are loose, dislocated, broken,
dirty, greasy or bear the risk of getting
in contact with water.
•
Route the power cable and hoses (if
any) of the product in a way that they
do not cause risk of tripping over.
•
Exposing the live parts or power cable
to humidity may cause short circuit.
Therefore, do not install the product
in places such as garages or laundry
rooms where humidity is high or water
may splash. If the refrigerator gets
wet with water, unplug it and call the
authorised service agent.
•
Never connect your refrigerator to
energy saving devices. Such systems
are harmful to your product.
A
1.6- Operational safety
•
Never use chemical solvents on the
product. There is the risk of explosion!
•
If the product malfunctions, unplug it
and do not operate until it is repaired
by the authorised service agent. There
is the risk of electric shock!
•
Do not place flame sources (lit
candles, cigarettes, etc.) on or close to
the product.
•
Do not climb on the product. There is
the risk of falling and getting injured!
•
Do not damage the pipes of the cooling
system with sharp or penetrating
objects. The refrigerant that might
come out when the refrigerant pipes,
pipe extensions or surface coatings are
punctured causes skin irritations and
eye injuries.
•
Unless recommended by the
manufacturer, do not place or
use electrical devices inside the
refrigerator/deep freezer.
