Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
22
Wire connection:
Connect the all cables accordingly:
—Power Supply cable,
—Ground wire to cutting plate,
—ARC START cable to plug of the plasma power source,
—DIV ARC+/- cable to Original Arc Voltage ports inside of the plasma power source.
Note: Ref. your plasma power source handbook for recommended Torch Height
for different thickness.
For detailed wiring solution, please refer to
www.arcbro.com/troubleshooting
Step 8: Pneumatic cutting part installation.
Parameter Set for Thin Sheet Cut.-
Pneumatic selection button on the panel.
Pneumatic mode
Assemble Step:
1-
Connect the air compressor to the Pneumatic
TCH connector; The pressure can be 0.3- 0.5
kpa.
2-
Mount the Pneumatic THC Lifter to replace
plasma THC Lifter and keep the red IHS
wire’s tip away from any conductive stuff.
3-
Mount the torch and load the water cooling
tip with the hose.
4-
Connect the water pump to supply water to
the water cooling tip. And use hose clamps.
5-
Wire connection.
