ACS6SE2 and ICS6SE3 60cm Cooktop Installation and Operation Manual
12
•
The brass links must be positioned as marked in the appropriate diagram and once established ALL
terminal screws must be tightened down firmly.
•
If when the hob is first switched on, only two of the zones work, you should recheck that the
terminal screws are all fully tightened between the links.
•
IMPORTANT:
The appliance must NOT be connected to the mains supply by means of a 13A plug
and socket.
•
The cable can be looped if necessary, but make sure that is not kinked or trapped when the hob is
in position. Care must be taken to avoid the cable being in contact with hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an appropriate replacement which
can be obtained from the Seller. The mains supply cable should be replaced in accordance with the
following instructions:
•
Switch the appliance off at the control switch.
•
Open the terminal block on the underside of the hob.
•
Unscrew the terminal screws fixing the cable.
•
Replace the cable with one of the same length and in accordance with the specification given
above.
•
The “green-‐yellow” earth wire must be connected to the terminal marked . It must be about 10
mm longer than the live and neutral wires.
•
The “blue” neutral wire must be connected to the terminal marked with letter (N) -‐ the live wire
must be connected to the terminal marked with letter (L).
MY APPLIANCE IS NOT WORKING PROPERLY
The cooking zones are not functioning or will not switch on.
★
Check that the mains electrical supply to the appliance is correct and working. Check the mains
fuse.
A humming sound is heard when a cooking zone is selected.
★
This is normal; the sound will disappear when the zone heats up.
The cooking zones have become discoloured
★
This maybe caused by burnt on remnants of food. This will not affect the working of the appliance.
However you should make sure that the cleaning instructions are being followed regularly.
Only two of the zones on my hob are working
★
You should recheck that the terminal screws are all fully tightened between the links.
IMPORTANT: If your appliance appears not to be operating correctly, then you
should disconnect it from your mains supply and then contact the Service
Department .
DO NOT ATTEMPT TO REPAIR THE APPLIANCE YOURSELF.
