17-06-2014 Page 4 of 14 ARB Copyright 2014
3789276
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC:
42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:
(08) 9244 3553
NSW:
(02) 9821 3633
ACT:
(02) 6280 7475
SA:
(08) 8244 5001
QLD:
(07) 3872 3872
NT:
(08) 8947 2262
TAS:
(03) 6331 4190
SECTION 2: Fitting the Mount Extrusions and Ladder:
2. i..
“Off the back” mounting
2.1) For off the back mounting only, cut the mount
extrusion on both ends
– leaving the second
drilled hole
2.2) For off the back mounting align the mounting
extrusions to run along the shortest direction of
the tent
2. ii.. “Off the side” mounting
2.3) For off the side mounting align the mounting
extrusions to run along the shortest direction of
the tent
Inside of tent
Outside of tent
2.4) To mount the extrusions use M8x40 Stainless
steel bolts (
11
) M8 Stainless steel washers (
20
)
and M8 silver nylock nuts (
22
)
2.5) Stand the tent on a clean surface on its side
2.6) Slide your hand between the mattress and the
base of the tent and push the bolt through the
pre-drilled hole (4 places)
2.7) Slide the nut into the smaller channel of the
mount extrusion align the mount extrusion as
noted in step 2.i. & 2.ii. and lightly tighten bolts
2.8) Check the mount direction.
!!Tighten bolts to 9Nm!!
2.9) Using the Self tapping screws (13), screw the
mount extrusion to the tent base on all four
corners in the outermost pre-drilled hole
