17-06-2014 Page 10 of 14 ARB Copyright 2014
3789276
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC:
42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:
(08) 9244 3553
NSW:
(02) 9821 3633
ACT:
(02) 6280 7475
SA:
(08) 8244 5001
QLD:
(07) 3872 3872
NT:
(08) 8947 2262
TAS:
(03) 6331 4190
Operations Manual ARB “Kakadu” Tent
1. Remove the travel cover from the tent by unzipping around the 3 edges and
slide the remaining edge from the rope track.
2. Release the hold down velcro straps on each side of the tent.
NB - When
closing the tent, do not use excessive force on the side retaining velcro
straps. See caution below.
3. Slide out the ladder until the locking pins engage. The ladder can now be
used as a lever to open the tent.
4. Rest the ladder on the ground, and enter the tent. Release the four bungee
cords from one side of the tent.
Note: if the angle of the ladder is too upright or does not reach the ground you
will require a ladder extension. See below.
5. Retrieve the spring steel rods (SSR), these are used to tension the outside
window awnings and flysheet. Hook the shaped end of the SSR into the eyelet
of the flysheet or window awning. Insert the other end of the SSR into the hole
in the base of the rooftop tent, passing through the eyelet in the rooftop tent
skirt. This will require you to bend the SSR so that the angle of the SSR is equal
to the angle of the hole into which it should be inserted. NB reverse this
procedure to remove the SSR from the hole in the base of the rooftop tent.
6. Repeat all the above steps in the reverse order to pack away your rooftop
tent.
