19
Exit the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Data
decrease
of data
Scroll
(UP /
DOWN)
Enter
selected
character
Par.
SETUP
"BASIC SETTINGS"
10
BASIC SETTINGS
FIRST SWITCHING ON - SETTINGS
If you have a configuration file (Backup), correctly saved on a pen-drive / SD card, press
F4
(
A
in Fig. 36) and follow the steps specified in par. 14.4.2.
IN ALL OTHER CASES, PRESS
F7
(
B
): SAVE USER AND MACHINE CONFIGURATION;
THEN START GUIDED SETUP BY PRESSING KEY
F8
B
PAR.
A
Fig. 36
ACTIVE SETTINGS AT THE END
OF GUIDED SETUP
self-propelled
machine
machine
with towed / carried
implement
Fig. 37
GUIDED SETUP
You can do the following:
SELF-PROPELLING MACHINE
Fig. 38
MACHINE WITH CARRIED / TOWED
IMPLEMENT
Fig. 39
GUIDED SETUP - MENU
IMPLEMENT / SELF-PROPELLING MACHINE BASIC
SETTINGS
• SWITCH BOX
Number of switches present on control panel:
4 switches
5 switches
7 switches
• MAIN VALVE
Main control valve installed on the control unit:
None
2 ways
(drain valve)
3 ways
(main valve)
• FLOWRATE REFERENCE SENSOR
Device used to calculate flowrate:
Flowmeter
Pressure sensor
: measured pressure is used to calculate target rate.
Both
: within the working limits the computer uses the flowmeter, otherwise it uses
the pressure sensor, ONLY if properly configured.
• TANK LEVEL SOURCE
Device used to read tank level:
Manual
: no external device connected
Filling flowmeter
Tank level sensor
GUIDANCE SETTINGS /
BASIC TRACTOR SETTINGS
• AUTONOMOUS GUIDANCE
: automatic control unit disabled:
None
• GPS RECEIVER
: ARAG receivers code 467016xx.
Smart-Ag
Smart 6
AgStar
Atlas
A100
: ARAG receiver code 520100.693.
NMEA
: all GPS receivers with NMEA183 protocol and with the following features:
- 10 Hz GGA message; latitude and longitude coordinates with at least 6 decimal
digits.
- 10 Hz VTG message.
- 0.1 Hz ZDA message.
- Serial port 57600 bps, n, 8, 1.
Demo
: monitor simulates the driving.
None
BASIC SETUP PROCEDURE IS NOW COMPLETE. NOW IT IS POSSIBLE TO START THE ADVANCED SETUP PROCEDURE,
DESCRIBED IN CHAP. 11. The system assigns to the monitor ONLY the suitable setup menus.
