ARAG Bravo 3 Series, Дополнение к инструкции

Страница: 14 / 28

3 MULTIROW SPRAYER PROGRAMME FUNCTIONS
3.1 Main differences compared to the version for the spraying machine
This software enables 5 different operating widths to be stored, in order to minimise the time required to
carry out settings when treating plots of land with different widths between rows.
This function has resulted in the modification or addition of new menus or procedures:
•
Programming the flow rate of the sectors (Menu 5.0, section 3.2):
possibility to programme 5 different flow rate combinations for the individual sections;
these values must be entered:
- so that the calculation of pressure will be correct;
- so that automatic adjustment functions correctly when you use the pressure transducer instead of the
flow meter.
•
Selection of the flow rate of the sectors (section 3.3)
•
Setting the operating widths (Menu 6.0 / 6.1, section 3.4):
this menu is used to store 5 operating widths (Menu 6.0 - Cnf X);
for each of these, the operating width must be entered for each individual sector (Menu 6.1).
•
Selection of the operating width (section 3.5):
a previously set operating width can be selected when programming the applied volume (Cnf X).
•
Setting the operating programmes (section 3.6):
this function is used to set 12 different operating programmes.
•
Selection of the operating programmes (section 3.7):
the button, which is used for selecting the previously set nozzle on the sprayer machine, is used for
selecting an operating programme (also preset) on the multi-row sprayer version; the operating
programme is the combination of operating width/dosing.
•
User programming:
programming of the nozzle flow rate values (Menu 4.0) has been replaced by programming of the flow
rates for the individual sectors (Menu 5.0).
English
14