sealed with fire cement.
Note :
The flue pipe must be fitted
inside
the outlet
spigot. Failure to do so could result in the spillage
of condensation running down the flue, (see
fig.1c)
ADJUSTING THE SELF
LEVELLING FEET IF APPLICABLE
Adjustment is as follows:
Position the stove on the hearth into its final
resting place.
On the rear leg of the stove, loosen the pozi
screw, and rotate the inner ‘cam’ shaped
levelling foot until this touches the hearth.
Re-tighten the pozi screw. Check the stove is
level with a spirit level.
Repeat for the other rear leg.
FIREBOX LINER PANELS
Arada DEFRA stove uses firebox liner panels at
both sides of the stove. The throat plate is not
supported by these liners, however the throat
plate must be installed before the liners can be
fitted, and the liners removed before the throat
plate can be removed.
To remove / fitting the liners
Open the fire door.
Remove the wood burning tray
Remove the lower side liners, carefully
allowing the upper side liners to slide down
to the landing plate
Remove the upper side liners
Replacing or fitting the liners is the reverse
of this procedure
Note : Cracking of the liner panels does not
effect the normal use or efficiency of the stove.
FITTING THE THROAT PLATE
This must be carried out with the wood
burning tray and side liners removed.
4
INSTALLATION INSTRUCTIONS
DEFRA Stove Installation and User Guide
