24
DiscGlo Operating Manual
There will be times when you will need to manipulate the hard-
ware on the DiscGlo. This section will explain how.
7.1 Adjusting the Lasers
T
has scored. From time to time, these may be knocked
outalignment. Follow the instructions below:he lasers are what the DiscGlo uses to sense when a puck
Verticle. There are
slight tilts to each setting due to the con-Note: These adjustments aren’t precisley Horizontal and
trols.
6.
Slide the Laser Adjustment Tab towards the front of
adjustments.the machine until it stops. This will assist in
the
laser
⬧
The
percentages
represent
the strength of the lasers.
Grounding Nut
2 . Go to Setup Menu.
3 . Select Diagnostics.
4 . Select Hardware test.
5 . Select Laser/Sensor Test.
⬧
This displays an image of the lasergrid.
You will need a 1/8” Allen Wrench for this task.
1 . Remove the top allen
screw and let the laser
access plate hang loose.
Laser
Sensor
Good Alignment
Poor Alignment
8 . Pull out the Laser Adjustment Tab until it stops. This
creates a pocket where the sensor sits.
Laser Adjustment Tab
Caution: Make sure you perform this step. The machine
