AR BLUE CLEAN 8840, Руководство по эксплуатации и обслуживанию

Страница: 6 / 20

AR BLUE CLEAN 8840 - 8860 - 8870 - 8880

Avoid vehicles transit on the high pressure hose.

While the machine is running do not cover it and avoid placing it where there’s low air
supply.

Avoid vehicles transit on the high pressure hose.

While the machine is running do not cover it and avoid placing it where there’s low air
supply.

If you are working indoors, it’s compulsory to install a fan to discharge the exhaust
gases outside.

The fan terminal must not be obstructed. Don’t leave the lance or any other object
near the exhaust outlet.

The nature of the gases as well as the high temperature are to be considered very
dangerous, the operator must thus be adequately informed in order to avoid being
scalded.

Don’t leave the machine outside when it rains or when the weather conditions are
bad. The operators must wear protection clothes while using the machine.

Do not leave the machine for more than 15 minutes working with the gun closed, the
water temperature would increase rapidly causing serious damages to the seal
system.

Each time the machine has to be switched off blow off the hose residual pressure by
using the gun.

Don’t put the hands in front of the machine’s water jet while the machine is working.

Do not use different fuels other than the ones recommended by the manufacturer.
WARNING !

Don’t carry out any operation on the machine before having unplugged it.

Don’t carry out any unwary operation on the electric cable and make sure the same is not
damaged.

Never direct high pressure water jets towards people, animals, electrical installations or the
machine itself.

Use always only clean water. Dirty water and chemical corrosive products are harmful for the
machine.

The machine is equipped with idle wheels; it thus recommendable to avoid placing the
machine on ramps or slanted floors. Do not tilt the machine by more than 20 °C (with full
tank).

It is forbidden to use plug extensions if the work environment is subject to water/humidity
presence which could cut the isolating conditions of the system. Always check the isolation of
the electric cable as well as the equipment’s integrity.

In case an extension is required, be sure that plugs and sockets have a protection type IP65
and that the power cord complies with the table reported here below.
VOLTAGE V EXTENSION LENGTH CABLE SECTION
USE AND MAINTENANCE HANDBOOK page 6
https://www.kipogeorgiki.gr/
https://www.kipogeorgiki.gr/