AR 100A400AM20, Руководство по эксплуатации и обслуживанию

Страница: 33 / 46

Model 100A400AM20
Rev A 17
2.4.6.6 State
Query to find the state of the amplifier.
Syntax: STATE?
Parameters: None
Response Format:
STATE=<space>xyza
Where:
x , y , z , and a are each an ASCII character representing a hexadecimal character.
They can be 0 to 9 or A to F.
Each hexadecimal character represents a 4-bit binary number. This 4-bit number is a
bit pattern which contains information about the state of the amplifier. The
definitions of these bit positions can be found in the table below.
Note: Bits labeled NOT USED may be read as a bit state of 1 or 0
BIT STATE
BIT
POSITION
BIT
DESCRIPTION
0 1 NOTES:
x
0 (NOT USED)
1 (NOT USED)
2 (NOT USED)
3
REMOTE
CONTROL
DISABLED ENABLED Response to mode switch position
y
0 POWER STATUS OFF POWER ON
1 (NOT USED)
2 (NOT USED)
3 FAULT STATUS OFF FAULT EXISTS
z
0 (NOT USED)
1 (NOT USED)
2 (NOT USED)
3 (NOT USED)
a
0 (NOT USED)
1 (NOT USED)
2 (NOT USED)
3 (NOT USED)
Example: To read the state of the amplifier, send the following query: STATE?<LF>
Response: STATE= 8100<LF> (Remote Mode and Power On)