AR 10010475, Руководство по эксплуатации и обслуживанию

Страница: 39 / 70

40T18G26A
Command Function Units Response format
RDPOHIW Returns over forward power warning setpoint (W) watts Pohi=[ ]W
SPOHIW Sets over forward power warning setpoint (W) watts
RDPOLOW Returns under forward power warning setpoint (W) watts Polo=[ ]W
SPOLOW Sets under forward power warning setpoint (W) watts
RDPRHID Returns over reverse power warning setpoint (dB) dBm Prhi=[ ]dBm
SPPRHID Sets over reverse power warning setpoint (dBm) dBm
RDPRHIW Returns over reverse power warning setpoint (W) watts Prhi=[ ]W
SPRHIW Sets over reverse power warning setpoint (W) watts
SYSTEM:ON;
Emulates pressing the System ON button from System OFF
( Exit Sleep Mode)
SYSTEM:OFF;
Emulates pressing the Power Save button. (Enter Sleep
Mode)
RDHTRAUTOOFF Returns heater auto off delay hours
SHTRAUTOOFF Sets heater auto off delay (see Table 9)
*IDN?; Returns the product model number [ ]
*STA?; Returns status string (see Table 7) [ ]
*STB?; Returns status string (see Table 8) [ ]
Table 3-4. Catalog of Status Codes
(The RDSTAT command causes the TWTA to return a string in the form STATUS=[ code ], where [ code ] is
an ASCII number whose meaning is given below)
Status Code Meaning
0 No command was given.
1 Last command was successful.
2 Last command is in process.
3 Last command failed to complete. Time-out.
10 Last command failed. Invalid command.
11 Last command failed. Data was unparseable.
20 Last set command failed. Data was beyond high limit.
21 Last set command failed. Data was beyond low limit.
22 Last set command failed. Data was out of range
23 Last set command failed. Data was wrong polarity
50 Last command failed. Local system does not have remote enabled.
51 Remote system is not ready to accept commands.
60 Command is not allowed in current system state.
901 Assert error: invalid table argument*
902 Assert error: invalid calibration*
* Please call a service representative if you observe this error.
Rev C 19