AR Blue Clean AR527, Руководство пользователя

Страница: 7 / 16

• After unpacking the
BLUE CLEAN POWER WASHER
, lay out parts and accessories.
Familiarize yourself with the parts in the package by comparing them to those li-
sted on the “PACKAGE CONTENTS” page.
• The
BLUE CLEAN POWER WASHER
requires some minor assembly. You’ll need a
Phillips screwdriver to install the plastic accessories holder which is also the electric
power cord holder.
• Install the plastic accessories holder on the back of your
BLUE CLEAN POWER WA-
SHER
(Fig.1). You’ll notice where the accessories holder meets the back of the unit
there are several male index posts which fit into female holes. The posts and holes
enable easy placement of the accessories holder and easy tightening of the screws.
Place the screws in the holes provided on the accessories holder and screw them in.
Do not use a power screwdriver. When the screw is completely tight (about four to
six turns) give a small final clockwise twist of the screwdriver. Do not overtighten.
After
Af Af the accessories holder is installed you will notice a square “hole” approxima-
tely in the middle of the holder into which our square detergent bottle may be
stored and easily retrieved if you decide to use a detergent in your
BLUE CLEAN
POWER WASHER
(Fig.2).
• Using one of the supplied screws install the small electric power cord holder below
the accessories holder so that the “L- shaped holder faces downward. The electric
power cord can now be wrapped around the accessories holder and the bottom
L-shaped holder while your power washer is not in use (Fig.1)
• Please refer to Fig. 9 for ff accessory storage location on the accessories holder.
• Install the garden hose adapter (GHA) and quick connect filter. It is made up of two
separate pieces. (1) A clear plastic adapter with a screen filter (about 3 inches long)
and (2) a blue/black collar attachment (Fig.3).
• First, remove the plastic shipping cover on the water inlet on the front of the power
washer. Attach the clear plastic adapter by screwing it into the water inlet (Fig.4).
Hand tight is fine. Next screw on the blue/ black collar attachment to your garden
hose (Fig.5). Slide the blue/ black collar onto the clear adapter (Fig.6). It will ”click”
into place.Now turn on the water at the faucet. The water is now connected to your
power washer.
• To remove the water hose, simply pull back on the blue collar, collar collar and it will slide off
the clear adapter. Note: this can be done at any time. Water will not come out of the
garden hose as the blue/black collar has a water check valve. Water will only flow
from the garden hose when it is connected to the clear adapter.
• The screen inside the clear adapter should be cleaned periodically. Insert a pen or
pencil in small hole at the end of the adapter. The screen filter will slide out (Fig.7).
Rinse it with clean water, then place it back in the adapter.
• Keep the nozzle cleaning wire, Which is taped to this manual for use in unclogging
the lance nozzle (Fig.8). If you lose the cleaning wire an unbent paper clip works
fine.
• You have now completed the assembly of your
BLUE CLEAN POWER WASHER
and
are now ready to begin using your electric power washer. Read and observe all
safety instructions.
UNPACKING & ASSEMBLY
Detergent
Bottle
Garden Hose
Adapter (GHA)
Plastic
Adapter
Fig.1
Fig.2 Fig.3
(GHA)
Fig.4 Fig.5
Fig.6 Fig.7
Fig.8
Fig.9