AR Blue Clean AR527, Руководство пользователя

Страница: 11 / 16

• When your pressure washing session has been completed, turn off the water sup-
ply and pull the trigger until water flow stops and IMMEDIATELY
IMMEDIATEL IMMEDIATEL turn off the power
switch located on the back of the pressure washer. (Fig.22) To prevent damage to
the pressure washer’s motor and/or pump. Do not allow the power washer to run
with no water flowing through it.
• The GHA should be stored in the accessories holder when your unit is not in use to
prevent loss or damage. (Fig.23)
• Remove high pressure hose from gun (Fig.24) and unscrew the other end of the
high pressure hose from the pressure washer. (Fig.25)
• Remove lance or detergent bottle from the gun and place in the accessories hol-
der. (Fig.23) Make sure to remove the leftover detergent from the bottle. Flush the
bottle and nozzle head with fresh water to prevent clogging.
• Unplug power cord and wrap around accessories holder using the extension tabs
at the 3:00 % 9:00 position and the L-shaped power cord holder/tab located at the
6:00 position. (Fig.27)
• Place the gun in the accessories holder in the left slot. Lances are pressed into and
stored in the half circle notches. (Fig.23)
• The pressure hose is stored on the hose reel located above the accessories holder.
With the front of the pressure washer facing towards you, insert the un-threaded
end of the power hose into the square hole and begin turning the handle away
from you (counterclockwise). (Fig.28) Pull the handle out horizon-tally with your
right hand in order to unlock it. When the reel has gone about 1/4 turn with the
fitting inserted into the square hole, place the hose under the indentation on the
side of the reel to keep it in place while winding it up.(Fig.29)
• When finished winding, push the handle back in to lock it in place. Please remem-
ber: the hose reel is only for storing the high-pressure hose. The hose must be com-
pletely removed from the hose reel each time you use the power washer.
• DO NOT store the power washer where it is exposed to freezing temperatures
unless you use Pump Saver. Freezing will damage the pump unless Pump Saver is
added to the unit after use. If not using or if storing your pressure washer for more
than one month run pump saver through it. See page 11 for more information.
STORAGE
Off
On
Fig.22 Fig.23
Fig.24 Fig.25
Fig.26 Fig.27
Fig.28 Fig.29