Aquos zero2, Руководство пользователя, Страница: 212 / 220

210
FCC RF Exposure Information
Your handset is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed
by independent scientific organization through periodic and
thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. The tests are
performed in positions and locations (e.g. at the ear and worn
on the body) as required by the FCC for each model.
The highest SAR value for this model handset as reported to
the FCC when tested for use at the ear is 0.35 W/kg, and
when worn on the body in a holder or carry case, is 0.54 W/kg.
Body-worn Operation; This device was tested for typical
body-worn operations with the handset kept 1.0 cm from
the body. To maintain compliance with FCC RF exposure
requirements, use accessories that maintain a 1.0 cm
separation distance between the user's body and the handset.
The use of beltclips, holsters and similar accessories should
not contain metallic components in its assembly.
The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and
should be avoided. The FCC has granted an Equipment
Authorization for this model handset with all reported SAR
levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this model handset is on
file with the FCC and can be found under the Display Grant
section of
http://www.fcc.gov/oet/ea/ after searching on FCC
ID APYHRO00280.
Additional information on Specific Absorption Rates (SAR) can
be found on the FCC website at
https://www.fcc.gov/general/
radio-frequency-safety-0 .
FCC ID Location
The device is electronically labeled and the FCC ID can be
displayed from Home Screen as follows:
In Home Screen,
(Settings) About phone
Authentication .
Water & Dust Resistance
Handset Water & Dust Resistance
Handset has IPX5
1
-, IPX8
2
-equivalent water protection and
IP6X
3
-equivalent dust protection with Card Tray closed firmly
leaving no gap between handset and Card Tray.
1 IPX5 compliant means that a handset continues to
function as a phone after being subjected to a water jet
(approximately 12.5 liters/min.) discharged from a nozzle
(inner diameter:6.3 mm), from all directions (approximately 3
m from handset) for at least 3 minutes.
2 IPX8 compliant means that a handset continues to function
as a phone after being gently submerged to the depth of
1.5 m in still tap water at room temperature, left there for
approximately 30 minutes, then removed from it.
3 IP6X compliant means that a handset continues to function
as a phone and its safety is maintained after being agitated in
a device containing dust of 75 μm or smaller in diameter for 8
hours and then removed from the device.
・Water and dust resistance may be affected under some
circumstances. Warranty does not cover malfunctions
resulting from misuse.
・Handset is compliant with IPX5 and IPX8 water protection
standards as well as IP6X dust protection standard.
However, ingress of dirt, sand, mud, metal powder, food,
beverage, sea water, etc. may cause malfunction.
■Handset Care
・Close Card Tray firmly leaving no gap between handset and
Card Tray. Any debris (single hair, grain of sand, minute
fiber, etc.) trapped between gasket and contacting surface
may allow ingress of water/dust.
・If handset is exposed to liquids with Card Tray open, they
may enter handset and cause electric shock or malfunction.
Discontinue use and power off.
・If handset is wet, wipe it with a dry cloth.
・Never open/close Card Tray with wet hands or while handset
is wet or has a foreign object adhered to it.
・Do not use External Connection Jack while it is wet or
obstructed by sand/dirt; may affect water and dust
resistance or may cause malfunction, burns or fire due to
electric shock, short-circuiting, etc.
・Handset is only water resistant against fresh/tap water
between 5
o
C - 35
o
C.