Aquion OptiPure BWS1500, Простое руководство по установке

Страница: 18 / 20

BWS1500 Simple Install Guide 18
(Ensure Storage Tank and Buffer Tank Valves are
open.)
Step 14a
Remove priming port plug on the top of the RP
Pump. Allow water from the Tank to fill Pump
until it begins to flow out of the port. Replace the
priming port plug.
Step 14b
Holding the 1” gray Optimized Water Line over
Storage Tank opening, plug in RP Pump power
and turn RP Pump on with the button located on
top. Allow to run until water flow is steady and
free of air.
Step 14c
After flow becomes steady,
close Buffer Tank Valve. This
will stop water flow through
the gray Optimized Water Line
and allow the Buffer Tank to
fill. When full, the RP Pump
should turn off.
Step 14d
If the RP Pump does not turn off, then the air is
not fully purged. With the Optimized Water line
in place over the Storage Tank opening, reopen
the Buffer Tank Valve, then when flow is steady
without air, close it and wait to see if Pump shuts
off. Repeat this process until Pump shuts off when
Buffer Tank is full.
v
Prime the Repressurization Pump
Tank Valves
Buffer Tank
Valve
Priming
port plug
Clear, steady flow
Pump ON
button