AquaVac TigerShark, Руководство пользователя

Страница: 7 / 20

7
5. Place the TigerShark in the pool. It will slowly sink to the bottom of the pool as the air
inside is released. Submersing by hand is helpful.
6. Connect the power supply to the GFCI protected outlet and switch to the “on” position.
The TigerShark will perform a self-diagnostics routine for several minutes before starting the
cleaning cycle.
The QC will go into Quick Clean cycle.
Caution: DO NOT switch power supply ON when the TigerShark is out of water. This may
result in damage to the pump & drive motor seals, which will VOID the warranty.
7. The TigerShark will automatically shut off after a cleaning cycle of 3 hours. (90
minutes for Quick Clean, 7 hours for the TigerShark2
®
). If your pool is cleaned in less
time than 3 hrs, you may shut the TigerShark off manually by switching the power supply
to the off position.
should a second cleaning cycle be required, switch off the power supply for 10
seconds and restart.
8. After the pool has been cleaned, switch OFF the power supply before removing the
TigerShark from the pool.
9. Remove the TigerShark from the water at the shallow end of the pool by pulling the
cable until the TigerShark reaches the surface. Then lift it out of the water using the
handle, NOT the cable.
caution:
When pulling the cable, reel it in hand-over-hand -
do not
reel it around
your arm.
neVer enter the swiMMing Pool when the aQua Vac is oPerating.
Optimum operating water temperature range for the TigerShark is 50ºF - 100ºF.
Remove the TigerShark from the pool after each use. Keeping the TigerShark permanently
in the pool may result in additional service requirements.