IsACQ210NMSC-0 (ENG) Rev. 250708-0
5 -16
Via dell’Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: [email protected]
After connection, the control unit will display a Plug-In
screen (Fig. 1), where a name can be assigned to the
connected sensor.
It may take several seconds for the control unit to
recognize the connected interface.
NOTE: The sensor’s name can be changed using
the control unit’s keypad.
If more than one of these sensors is connected, the user
may assign different names for each one to facilitate
menu navigation.
Displaying the read value
After the probe has been connected through the ap-
propriate interface, the values read by the probe will
be displayed on the main screen.
If several sensors were connected, their values can be
checked in order by pressing the
and
keys.
Conductivity Menu
Once the probe and interface are connected, the
“Con-
ductivity”
menu will appear in the
“Main Menu”
,
where all of its settings can be programmed.
All sensor menus have the same structure in order to
make them more intuitive and simple.
Change Name
This option modifies the name given to the sensor
(Fig. 4).
To use this option, proceed as follows:
Main screen
Main Menu
Conductivity
Change
Name.
•
Select the letter to insert using the
keys and move
within the word using the
keys. When finished,
press
“Enter”.
(Fig. 2)
Mon 11/06/07 15:05
PU01 A B C D E F G H
Conductivity 680 µS
(Fig. 3)
Conductivity
Change Name
Programs
Data Record
Alarm
Calibrate Sensor
English
(Fig. 4)
Cond_
(Fig. 1)
New device connected
S01
Conductivity
