AquaTerra Fairfax, Руководство пользователя

Страница: 13 / 24

10
INITIAL START-UP
-
When the spa is first powered up the control system begins
a 2 minute Startup Mode. Different codes will display on the screen. Once Startup
Mode completes, the actual temperature
is displayed on the screen, and the spa
will then begin to heat, maintain
the water temperature and the
first filter cycle will start 5 minutes
later. Your spa has been designed
so that it will automatically heat the water to
the factory set temperature of 100 ° F unless
you set the spa to a different temperature.
If power is disconnected from the spa, it will
automatically revert back to the last saved
set temperature when power is reapplied.
DISPLAY OVERVIEW
TEMPERATURE ADJUSTMENT (80°F-104°F/26.5°C-40°C)
The temperature can only function between 80°F - 104°F / 26.5°C - 40°C. The last measured
temperature will constantly display on LCD.
Press the
Up / Plus or Down / Minus buttons to display the set temperature
(desired temperature) and indicator . Each time either button is pressed
again, the set temperature will increase or decrease depending on which
button is pressed. After five seconds, the LCD will automatically display the
current spa temperature.
CONTROL PANEL OPERATION
Temp Down/
Minus
Temp Up/
Plus
Jets 1 Jets 2 Light
Mode
Pumps icon
The "Pump" indicator numbers light up
when the pumps are in high speed, and
flashes when the pump is in low speed.
Service icon
A problem has
been detected. Do
not enter the water!
Spa service is
required.
Temperature
& message digits
˚F/ ˚C
Filter Cycle icon
The "Filter Cycle" icon lights
up when filter cycle is on. The
icon flashes if the filter cycle is
disrupted.
Smart Winter Mode icon
The "SWM" icon
automatically turns on
when freeze protection
is active. It flashes while
system purges the spa
plumbing.
Set Point icon
The "Set Point" icon
automatically turns on
when set point setting
menu is activated.
Light icon
The "Light" icon lights up
when the light is on.
Heater icon
The "Heater" icon lights up
when the heater is on. It flashes
when:
1- there is a call for heat and
heater has not started yet,
2- heater has just turned off and
element is cooling down or
3 - not enough current available
to start heater