AquaStar Loxone, Руководство по эксплуатации

Страница: 11 / 20

11 www.praherplastics.com
REL1 REL2 REL3
VDD DQ GND
+5V PS2 GND
+24V PS1 GND
Electrical Connection 11
a) Connection to the supply voltage
100
– 240 V AC 50/60 Hz
~
b) Connection for pump
Potential free: 250VAC 8A at cos
φ=1, 30VDC 8A
(Use a Auxiliary relay at greater loads)
For position ’filter’, ’backwash’, ’rinse’, ’waste’ and ‘circulate’ and after a time
lag of approx. 10 sec. the clamps [13 -> 14] are connected.
c) Connection for ball valve
Potential free: 250VAC 8A at cos
φ=1, 30VDC 8A
(Use a Auxiliary relay at greater loads)
With switched off actuator, on position FILTER and CIRCULATE, the clamps
[G→3] are interconnected. On position WASTE and during the whole backwash
cycle the clamps [G→4] are interconnected.
~
d) Potential-free relays
Potential-free: 250VAC 5A at cos
φ=1, 30VDC 5A
(Use a Auxiliary relay at greater loads)
The potential-free relays Rel1 to Rel3 are designed as NO contacts and act as a
functional enhancement in the Loxone system.
e) Pressure sensor for Loxone Pressure Sensors
The PS1 terminal is intended for an evaluation of 0-10V. The maximum voltage is
10V. The 0...0.3
or 0…6 bar Loxone pressure sensor is optionally available.
f) Pressure sensor for Praher Pressure Sensors (System Pressure)
The PS1 terminal is intended to evaluate 0.5-4.5V. The maximum voltage is 5V.
The 0 ... 6 bar Praher pressure sensor is optionally available.
Connection: Te5V

Contact sensor 1
Terminal PS2

Contact sensor 2
Terminal GND

Contact sensor 3
g) 1-Wire interface
This interface is intended to connect 1-Wire sensors by Loxone.
h) SMA Connector
The antenna is included and has to be screwed in to the SMA connector ST5 to
get a connection to the Miniserver.
L1 N
13 14
4 G 3
NO COM NC NO COM NC