Aquaport AQP-TAP-4G, Инструкция по установке и эксплуатации

Страница: 7 / 14

INSTALLATION AND OPERATING INSTRUCTIONS 5
C. Faucet Installation Instructions
Warning:
Do not use any tools to fix the flexible metal
connectors. Hand tight pressure only.
Warning: Do not over tighten the Flexible Metal Connectors to
the tap connections, as cross threading and leaking can occur.
Water tightness is not improved and the o-rings can be damaged.
Note:
This tap must be installed with an isolating tap in
accordance with local authority installation codes.
1. Shut off mains water supply and drain any excess water from
the old tap before removing the tap from the sink.
2. Locate the Mains Cold and Hot Water Connections (2 & 3) inlet
on the tap (marked with the letters C and H).
3. Firmly hand tighten the Flexible Metal Connectors (9) into
the tap inlets, being careful not to over tighten and to avoid
damage to the o-ring seals.
4. Thread the Flexible Metal Connectors (9) and tap shanks (4 &
5) through the Mixer Base (14a).
Note:
Check to make sure the mixer base o-ring is still present and
is fully seated in place.
5. Mount the tap onto the sink hole, by threading the Flexible
Metal Connectors (9) and tap shanks (4&5) through the sink
hole and position the Mixer base (14a) between the sink and
the tap.
6. Ensure that the Flexible Metal Connectors (9) are positioned
towards the front of the sink with the lever handles pointing
towards the user and tap shanks (4 & 5) are positioned at the
back.
7. Thread the Fixing Plate Washer (14b) and then the Fixing Plate
(14c) onto the Ambient Filtered Water Shank (5).
8.
Screw Locking Nut (14d) onto the Ambient Filtered Water
shank (5) and lock the tap onto the sink by tightening the
Locking Nut.
Note: Tap levers must never be used to align the tap in centre
positions after Locking Nut has been tightened. Damage to levers
will occur. Loosen Locking Nut before aligning the tap in the centre
of the sink.
9. Place the Brass Adapter Red Washer (10) into the female end
of the Brass Adapter (11) and screw Brass Adapter onto the
end of the Ambient Filtered Water Shank (4).