`
ENGLISH
FILTER-FILTERN
FILTRATION
FILTRACION
FILTRAZION
1.- Take off the clamp and the valve with the gasket.
2 - Cover the opening of the inner pipe in order not to drop sand inside it.
3.- Fill the filter with water to half capacity.
4.- Pour the required quantity of sand inside the filter.
5.- Clean the seating of the gasket joint.
6.- Fix the filter valve in place.
FILTRATION PROCESS
The selector valve has a handle of 6 positions that selects any of the
necessary operations to obtain the maximum efficiency from the filter.
IMPORTANT: Always switch off the pump, when changing the position
of the selector valve.
FILTRATION
With the pump switched off, place the handle of the
selector valve in the” FILTRATION” position.
Switch on the pump.
During this operation, it is advisable to observe the
pressure gauge from time to time as this indicates the
degree of saturation of the filter. When the pressure
reaches 18.5 PSI a “BACKWASH” should be carried out.
The main drain and skimmer valves will be regulated
according to the quantity of floating material found on
the surface of the water. Bear in mind that with the main
drain valve fully open there will be little suction from the
skimmers. If the surface sweep of the skimmers is to be
stronger, reduce the flow from the main drain.
