`
ENGLISH
3.- In case of a filter with top valve, install the
selector valve on top of the filter with the clamp. Make sure that the joint
between the valve and the filter are correctly placed.
4.- Perform the three connections of the selector valve: pump piping to the
valve, valve to the waste drain and valve to the pool return. Each of these
three outlets is clearly identified on the valve.
5.- Set the gasket, the valve, the clamp and the manometer (see exploded
view). It is not necessary to use teflon tape, as the watertightness is
guaranteed in this case by the joint. Do not tighten the manometer with a
tool, as manually will be sufficient.
SAND LOAD
In order to obtain maximum efficiency from your filter, it should be filled with
silica sand with a grain size classification of 16 / 32 inches. With the quantity
indicated on the plate specifying the characteristics, proceed as follows:
First, fix the
gasket
Then, position
the valve
Last, place the
clamp
Fix the pressure
gauge
1
2
3
4
