Quartz Digital Concealed
installation instructions
Page 10
Feed the control connection end of the data
cable through the centre hole in the mounting
template. Run a bead of silicone sealant in the
mastic groove on the back of the mounting
plate and press into position onto the finished
wall surface. Ensure the data cable is held
securely by the narrow middle slot of the
mounting plate and fix to the wall using the
screws provided.
10
Plug the data cable into the rear of the
controller and slide onto the mounting plate.
Secure the controller to the back plate with
the fixing screw located at the base of the
controller using a small Posidrive screw driver.
11
Connect the outlet pipe to the mixed water outlet on the Digital processor. Using
pipe clips as appropriate, ensure that all pipe work is perpendicular to the processor,
i.e. not putting any strain on the fittings.
12
!
Do not solder any additional pipe work to the 15mm copper pipe from the Digital
shower system as the low voltage data cable could be damaged. Instead, use push-fit
fittings where necessary, to connect additional copper piping.
TO ENSURE OPTIMUM PERFORMANCE USE THE MINIMUM AMOUNT
OF ELBOWS.
TO MAXIMISE FLOW RATES WE RECOMMEND USING COPPER PIPE WITH THE
MINIMUM AMOUNT OF ELBOWS.
BEFORE ANY ELECTRICAL ADJUSTMENT IS ATTEMPTED, THE ELECTRICITY SUPPLY
MUST BE TURNED OFF AT THE MAINS SWITCH.
ELECTRICAL INSTALLATION MAY ONLY BE CARRIED OUT BY A QUALIFIED PERSON.
!
