AQUALEAK EMS-10X, Инструкция по эксплуатации

Страница: 39 / 53

Environmental Monitoring System (EMS-5X, 10X and OS) Instruction Manual
39
Part 1 of 3: Prepare the .apk software update as follows:
1.
Copy the EMS software to install (.apk file)
onto a USB stick .
2.
Ensure the EMS is powered ON and at the
Summary screen . Open the front of the
Master Panel to access the USB Port located
at the rear of LCD display.
3.
If appropriate, switch SW1 can be set to
the ON position to bypass the reboot relay
(section 3.2.2 Reboot Relay ).
4.
Plug the USB stick into the EMS USB port .
Wait a few seconds for the USB stick to be
recognised.
Part 2 of 3: Install the .apk software update as follows:
1.
Summary screen: Tap ‘ Engineer ’ > Enter
Pin ( default 1234 ) > Tap ‘Exit Application’ .
2.
EMS screen: Tap the Menu Icon (i.e. the
circular button with 6 dots; Figure 27 ). The
Android Operating System menu will
appear, along with the
ASTRO File Manager
icon .
3.
Tap the ASTRO File Manager icon ( Figure
23 ). The ASTRO File Manager screen will
appear, and the USB disk will be opened
automatically.
4.
Tap the .apk software update icon to
install ( Figure 27 ).
5.
A ‘Complete action using’ dialog box will
appear. Tap ‘Package Installer’ and then
‘Just Once’ ( Figure 27 ).
6.
A confirmation dialog box will appear. Tap
‘Install’ to confirm and begin installation
( Figure 27 ).
7.
After a while, the confirmation dialog box
will state that the .apk software update has
been successfully installed
(
Figure 27 ).
8.
If the confirmation dialog box does not
close automatically, tap
‘Done’ to close it
( Figure 27 ). The EMS will return to the
ASTRO File Manager screen .
Part 3 of 3: Finalise the .apk software update as follows:
1.
ASTRO File Manager screen: Tap the three
dots in the top bar located in the right-
hand corner . A drop-down menu will
appear ( Figure 27 ).
2.
Tap Exit in the drop-down menu to leave
the ASTRO File Manager and return to the
Android menu .
3.
Tap the EMS icon to load the new .apk
software update.
4.
The procedure for loading new software
onto the EMS Main Panel is now complete.
Ensure
switch SW1 is set to the OFF
position (see 3.2.2 Reboot Relay ). Remove
the USB stick from the EMS USB Port.