Aquaguard AGWAV20, Руководство пользователя, Страница: 19 / 24

Troubleshooting
Situa � on Possible Cause Correc � ve Ac � on
Low or no chlorine residual
In pool
Low stabilizer (Cyanuric acid level in pool
water)
Add stabilizer to maintain 20-30
PPM per pool professional’s
recommenda � ons.
Insu ffi cient run � me Increase daily run � me.
Recommend 1 hour of run � me per
10 degrees ambient temp.
Chlorine Output percentage set too low Increase the Sani � zer Output Level
(see page 15)
Recent increases in weather temperature
without increasing the Sani � zer Output of
the system
Increase the Sani � zer Output Level
(see page 15)
Temporary loss of chlorine due to heavy
rain, leaves, fer � lizer or heavy bather
load, recent party, or pets using pool. Loss
of salt due to rain or added water.
Set Sani � zer Output to BOOST
(Super Chlorinate) for 72 hours.
Recheck--if s � ll too low, super-
chlorinate with outside source.
(Take pool water sample to pool
professional) Add salt.
Low or no chlorine
Low salt level (less than 3,000 PPM).
System Status light is fl ashing/ service
light is yellow / solid.
Increase Salt level by adding salt
according to chart on Page 10
High Phosphates/Metals
High nitrate level. Metals
present in pool water.
Contact Pool Professional.
Phosphates in pool water Use phosphate remover as
instructed or contact Pool
Professional
New pool water, or not shocked properly
upon startup.
Super-chlorinate pool with outside
source.
Clogged or dirty cell Remove cell from housing to clean
(see “Cell Maintenance,” page 16)
Status light is fl ashing and
service light is on.
Pool water needs salt.
Cell is clogged or dirty.
Water temperature is low
Insu ffi cient water fl ow
Insu ffi cient water fl ow—dirty fi lter
Sensor tab (top of cell) issues
Test salt level of water. Add salt
(page 10) if necessary
.
Check and clean cell (pp 16-17)
Check water temp (if below 60
degrees, turn system o ff )
Make sure pump is running. Check
and correct all valve alignments
Follow fi lter cleaning procedures
Clean o ff any calcium on sensor tab.
Make sure there is not an air bubble
at point of sensor tab in cell housing
– if there is, contact your pool
professional or our tech hotline: 1
866 972-SALT
19