Locating your Feature Pump
The pump should be located on a firm and level base in the pond or water feature. The
pump should be covered with water at all times. Make sure there is ample cable from the
mains supply.
Place the pump in the desired location and then attach the hose connector that is suited to
your water feature.
Tip:
The larger 1” hose fitting will give maximum performance when fitted to the pump.
The flow control can now be adjusted, as seen in the adjusting flow control diagram.
INSTALLATION
7
Turn flow adjuster
clockwise to
increase flow,
anticlockwise to
decrease flow.
Cut & Remove
unwanted Hosetails
1"/25mm
Pump outlet
1"/25mm
Hose
Recommended
Cut Cut Cut
3/4"/1
9mm
1/2"/1
2mm
Connecting Outlet Hose
Warming the hose in a bucket of
boiling water can aid fitting.
Always ensure that the
smaller diameter hosetail
is cut off and removed to
prevent reduced pump
performance.
Use the shortest possible
hose lengths to minimise flow
restrictions. Avoid folds and
kinks in the hose, which will
reduce flow and filter performance.
