Step 3.3
Step 3.2
Remove the wall profile and drill the marked points using a 6mm masonry drill bit, once this is done insert the wall
plugs.(Diagram 3.2)
.
Step 3.1
Place the side panel Wall Profile (part 33) onto the tray,roughly 10mm away from the front edge of the end cap.
Level the wall profile using a spirit level then mark the profile through the pre-drill holes on the wall profile
(Diagram 3.1)
10mm
Secure the wall profile onto the wall using ST4X30 screw x4.(Diagram 3.3)
3.1
3.2
3.3
inside
Step 4.1
Step 4.2
Step 4.3
Carefully lift the Side Panel Glass (Part 34) onto the tray,insert it into the wall profile channel. It allows 20mm for
the adjustment.(Diagram 4.1)
Cut the bottom rail(part 12) 25mm away then insert it into the end cap L(Part 10) fitted on the fixed panel wall profile.
Drop a little bit silicone sealant into the groove of the side panel bottom fixing (part 35), then fit it onto the side panel glass
and bottom rail,drill the hole on the tray/floor then insert the wall plug,attached it onto the tray/floor using screw ST 4X30
.
(Diagram 4.2)
4.1
4.2
Insert the fixing seal from top to bottom to fix the side panel glass onto the wall profile from inside of the enclosure.
20
