❏
DTXC2100 – DuraTrax
®
7.2 volt 1500mAh NiCd battery
pack (1 required)
❏
DTXP4000 – AC/DC Piranha
™
Peak Power charger
❏
FUGP7300 – Four (4) “AA” batteries.
Eight (8) “AA”
batteries are required for the transmitter.
As with any hobby, it is a good idea to assemble a useful
collection of tools to bring along anytime you head out to the
pond. Here are some items you may wish to keep handy.
❏
#2 Phillips screwdriver (HCAR1024)
❏
1.5mm Hex driver (HCAR1150)
❏
4mm Socket or wrench
❏
Paper towels
❏
Spray-on glass cleaner
❏
Hook & Loop material (GPMQ4480)
❏
Hobby knife (HCAR0109)
BOW:
The front of the boat
STERN:
The back of the boat
PORT:
This is the left side of the boat when aboard and facing
the front (bow). An easy way to remember this is that port and
left both contain four letters.
STARBOARD:
This is the right side of the boat when aboard
and facing the front (bow).
HULL:
The body of the boat.
DECK:
The top of the boat
Decals have been provided for your Pro Fisherman. Simply
cut them out, peel, and stick! See the box for recommended
decal placement.
After the decals are applied, press-fit the boat’s steering
wheel into place as shown.
The package containing the
steering wheel is located inside the hatch compartment of
the hull.
Transmitter Assembly
Important Note:
The
transmitter is not water resistant
and
should never come in contact with water.
❏
1. Remove the transmitter antenna from the parts bag and
thread it into the top of the transmitter. To ensure that the
antenna is attached, lightly pull on the base of the antenna. If
it slides out, it is not installed properly.
❏
2. Slide off the battery door
on the bottom of the transmitter.
Install 8 new “AA” batteries into
the bottom of the transmitter in
the configuration molded into
the battery holder. Re-install the
battery door onto the bottom of
the transmitter.
❏
3. Turn the transmitter “ON”
using the switch on the front. The
red LED light next to the on/off
switch should light up. If the LED
does not light up, turn the
transmitter off and check to
make sure that the batteries are
installed properly.
If you see a
flashing LED, the batteries are
low and need to be replaced.
Battery Pack Installation
IMPORTANT! Never leave a charger and battery pack
unattended while charging. Use only the recommended
battery pack and an appropriate charger. Do not attempt to
charge the battery while it is installed in the Pro Fisherman.
Refer to the instructions included with your charger for
proper battery charging procedure.
❏
1. Remove the forward hatch by grasping the fishing seat
and gently lifting as shown to reveal the battery compartment.
Peel the backing off of the supplied hook & loop material and
apply the “loop” side to your 6-cell battery pack.
ON / OFF
THROTTLE SERVO
REVERSE
STEERING
SERVO
REVERSE
POWER
LIGHT
STEERING
TRIM
ADJUSTABLE
STEERING
RATE
THROTTLE
TRIM
Install (8) new "AA" batteries
FINAL ASSEMBLY
BOAT TERMINOLOGY
USEFUL TOOLBOX ITEMS
ITEMS REQUIRED FOR COMPLETION
3
Содержание Pro Fisherman
Страница 7: ...7 EXPLODED VIEWS...
Страница 8: ...NOTES Date Date...
