background image

5

Tuck the wires neatly under the decking.

ARMING PROCEDURE

With the transmitter on, plug a charged battery into the 

controller.

You will hear a chime with a beep. bee-daa-beep--beep!

Squeeze the throttle trigger fully, you will hear two beeps. 

“beep-beep”.

Relax the throttle trigger; you will hear three more beeps. 

“beep-beep-beep”.

The boat’s power system is now armed and ready to run.

NOTE:

 The arming procedure has to be done each time you 

plug the pack into the boat.

Place the canopy on the boat, sliding the front pegs into the 
cowl. The back will be held by the small magnets. Your boat is 
now ready for operation. It is best to tape the canopy closed. 

Tape is the best system for keeping water out of your boat. 

We have supplied you with a small roll to get you started. You 

can also upgrade to our Premium Radio Box Tape, making 
application and removal much easier. (GrimRacer Pro Radio 
Box Tape AQUB9514)

Launching and Driving Your

GP-1 Ultra Hydroplane

Place the boat in water that is at least 12" (305 mm) deep. Make 
sure the water is free of weeds, sticks or other fl oating debris.

Your GP-1 Ultra Hydroplane is designed to turn right. It’s also 

important to note this boat is FAST! Having said this, it is 
best to be quite aggressive with the throttle to overcome any 
cavitation that the boat might encounter as it starts to move 
forward when launched. It’s also a good idea to run in a larger 
pond. Do not run your GP-1 Ultra Hydroplane in a pool.

After you have completed a run, it is best to FIRST unplug the 

LiPo battery. This safely powers down the boat before turning 
off your transmitter.

IMPORTANT:

 If your boat takes on a large amount of water 

and stalls, don’t worry, 

foam fl otation will keep it from 

sinking.

 You will have to retrieve the boat and remove the 

canopy to release any water that might have entered. If the 
inside is fl ooded, remove the transom plug from the back of 
the boat and let the water drain. Allow the boat to fully dry 
before operating it again. Remember to re-install the transom 
plug before running.

Maintenance

It is important to remove and re-lubricate the driveshaft after 
running for the day. Make sure the battery pack is unplugged. 

You will need a 2mm hex wrench, GrimRacer Cable Grease 

and some paper towels.

Using a 2mm hex wrench, loosen the screws holding the drive 
cable to the motor coupler. It is important to note that there 
are two set screws holding the shaft in position.

Содержание GP-1 ultra









Отзывы: