Aquacal STK0247, Инструкция по установке и быстрому запуску

Страница: 14 / 19

Page - 11
Use Setup from USB
A file, previously saved onto a USB thumb drive, can be
used to configure the heat pump.
PLEASE NOTE:
This file will take advantage of any custom configurations entered by the installer on prior
installations. The file will contain the equipment, group, and schedule settings.
Other settings such as multi-unit installations, external control mode, etc. will still need to
be configured.
DANGER
Failure to heed the following will result in injury or death.
l
Deactivate power while routing wiring to control board.
l
RISK OF ELECTRICAL SHOCK FROM ENERGY STORED IN CAPACITORS - MODELS EQUIPPED
WITH VARIABLE FREQUENCY COMPRESSOR DRIVES STORE ELECTRICITY EVEN AFTER THE
POWER HAS BEEN DEACTIVATED AT THE POWER BREAKER.
Wait for 2 minutes after the shut down
of equipment before servicing.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
Figure 3 - USB Thumb Drive Port
1. Turn off power at heat pump's power disconnect.
2. Wait two minutes for capacitors to discharge before
proceeding.
3. Remove heat pump electrical access panel.
4. Insert thumb drive into the heat pump's USB thumb drive
port on the control board.
5. Activate power to heat pump. Do not touch thumb drive or
electrical components inside heat pump. Risk of electrical
shock can result in injury or death.
6. When installation wizard appears, select start.
7. Navigate to and select "USE SETUP FROM USB".
8. After heat pump has successfully loaded file and restarted,
deactivate heat pump at power breaker.
9. Wait two minutes for capacitors to discharge before proceeding.
10. Remove thumb drive.
11. Reinstall heat pump's access panel.