Aquacal STK0247, Инструкция по установке и быстрому запуску

Страница: 10 / 19

Page - 7
Pool / Spa, Valves, Single Speed
This preset configures the heat pump as
follows:
l
Two actuator valves are configured named
intake (on "VA INTAKE") and return (on
"VA RETURN").
l
A single speed circulation pump is
configured to use the relay "A" connection
point on the expansion board.
l
A pool schedule is configured (Everyday
from 8:00 am to 6:00 pm)
When pressed, the "Pool/Spa" button will display with three choices.
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Spa - With an initial timer of 2 hours at 104° F.
3. Spa - With an initial timer of 2 hours at 96° F ( 104° F with an installed OTA kit
).
4. Schedules
Pool Only. No Valves, No Pump
This preset configures the heat pump as
follows:
l
No valves actuators are configured.
l
No circulation pump is configured.
l
No schedules are configured.
When pressed, the "Pool/Spa" button will display with two choices:
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Schedules - Without an active schedule, the heat pump mode is initially set to "OFF".
Pool Only, No Valves, Pentair VS
This preset configures the heat pump as
follows:
l
No valves actuators are configured.
l
A Pentair (or Sta-Rite) variable speed
circulation pump is configured.
l
A pool schedule is configured (Everyday
from 8:00 am to 6:00 pm)
When pressed, the "Pool/Spa" button will display with two choices.
1. Pool - With an initial timer set for 48 hours at 85° F.
2. Schedules