TROUBLESHOOTING
MOVES SLOWLY OR DOESN'T SEEM TO BE VACUUMING
•
The solution is to make sure that the filter bag is clean.
•
Check to see that the suction ports are not clogged or blocked.
ALL LED LIGHTS ARE BLINKING ON THE POWER SUPPLY
•
Check to see if the unit is out of water.
•
Check to see if the filter bag is stuck in the motor protection screen.
•
Check to see if the propeller is stuck.
•
To restart, press the power button once. Cleaning program will resume from where it left off.
THE FLOATING CABLE IS COILED UP
•
Change the axle set-up. Unit is most likely turning too sharply or in the same direction for too many cycles.
•
Use the Detangler to straighten out the cable (certain models).
•
Let the tangled cable lay flat in the sun; this will make it more pliable and easier to straighten.
•
Never place more cable in the pool than it takes to get to the other side. (TIP: Mark the cable with black electric tape at correct length)
UNIT IS NOT SUCKING UP DEBRIS
•
Check to see that you've properly set-up the unit and the power supply is ON.
•
Check to see if the propeller is stuck.
•
Adjust the suction ports on the bottom of the unit.
•
Make sure the filter bag is clean.
UNIT IS STUCK IN THE MIDDLE OF THE POOL BUT THE UNIT STILL PUMPS OUT WATER
•
Check to see that there is nothing obstructing the cleaner or that the cleaner is not stuck on any loose objects in the pool.
•
The suction ports are far too low to the pool bottom. Adjust as necessary.
UNIT LOOKS LIKE IT IS MOVING IN THE SAME AREA OF THE POOL AND DOES NOT CLEAN OTHER AREAS
•
Change the axle set up by adjusting the pin configuration. This will help move the cleaner in a different direction to clean.
•
Always start your cleaner in the shallow end of your pool.
•
Select the appropriate power supply setting be it Large or Small pool (certain models).
UNIT DOES NOT COVER THE ENTIRE POOL
•
Check to see that the filter bag is thoroughly clean.
•
Adjust the timing cycle on the power supply (certain models).
•
Check to see that the axle area is not blocked.
•
Check and change your pin configuration.
For any additional questions
or concerns please call
1-800-221-1750
280 Grove Avenue
Cedar Grove, NJ 07009
1-800-221-1750
www.aquaproducts.com
