PLEASE READ THIS IMPORTANT SAFETY INFORMATION
WARNING: DO NOT operate shower if frozen, or suspected of being frozen.
It must thaw out before using.
DO NOT operate the unit if the showerhead or spray hose becomes
damaged.
DO NOT restrict flow out of shower by placing showerhead in direct contact
with your body.
DO NOT operate the shower if water ceases to flow during use or if water
has entered inside the unit because of an incorrectly fitted cover.
WARNING: If restarting the shower immediately after stopping, be aware
that a slug of hot water will be expelled for the first few seconds.
PLEASE READ THIS IMPORTANT SAFETY INFORMATION (CONT.)
IMPORTANT: This appliance is not intended for use by persons (Including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
IMPORTANT: To comply with water regulations, building regulations or any specific local water
company regulations and should be in accordance with BS EN 806. A double check valve must be
fitted with all flexible shower accessories where it is possible that the showerhead may come into
contact with used water i.e. In the bath or shower tray.
IMPORTANT: Before turning on the water supply to the shower unit the water supply pipe should
be flushed out to remove debris. After flushing the pipework ensure that the shower unit is
positioned squarely on the wall and tighten the screws. Tighten all plumbing connections and
check the pipework for leaks.
IMPORTANT: Ensure that the terminal block screws are fully tightened and that no cable insulation
is trapped under screws. Ensure the cable clamp is used to secure the cable. The earth continuity
conductor of the electrical installation must be effectively connected to all exposed metal parts of
other appliances and services in the room in which the shower unit is installed.
CAUTION: Check there are no hidden cables or pipes before drilling holes for wall plugs.
Exercise great care when using power tools near water. The use of a residual current device
(RCD) is recommended.
WARNING: If re-starting the shower immediately after stopping, be aware that a slug of hot water
will be expelled for the first few seconds.
ATTENTION: Do not operate the shower unit if the showerhead or hose becomes damaged.
The shower is designed and approved to EN-60335 with the showerhead provided.
Under no circumstances must any showerhead that is not approved by the manufacturer be used
with this product.
IMPORTANT: The shower unit must be full of water before heat settings are used.
IMPORTANT: Turn the Temperature control knob anticlockwise until the valve is fully open before
switching on the unit.
This will ensure a fast fill up of the unit when the shower is first switched on.
