Obstruction with outflow - Shower Hose,
Overhead or hand shower
TROUBLESHOOTING
Symptom
Likely Cause/s
Action / Remedy
No water flow.
Water temperature
too Insufficient water
flowing hot.
Water isolating valve in off position.
Outlet hose mesh filter blocked.
Power supply not on.
Turn off water supply,
Remove the outlet hose from the shower,
remove mesh filter and clean.
Turn on.
Insufficient water flowing hot.
through the shower.
Clean the outlet nozzles in the
Overhead / Handshower Increase the
flow by adjusting the temperature control
knob to cooler setting.
Reduce the power setting.
Water pressure is at minimum requirement.
Check running pressure
(minimum of 1.0 bar).
Wait until pressure increases.
Shower temperature is set too high causing
the hermal cut out to turn off the heating
elements to reduce the water temperature.
Shower temperature
cycles between hot
and cold.
Water from pressure
relief outlet - PRD
activated.
Call supplier for customer service
assistance.
Shower runs hot and
cold during use.
Turn shower temperature control
anti-clockwise to reduce the water
temperature.
