Simpool pH model
INSTRUCTION AND MAINTENANCE MANUAL
Programmable digital peristaltic pump
ENGLISH
ADSP7000407
rev. 1.2
27/03/2015
57/313
Fig. 17- pH Pump Calibration Menu
3.3.7
R
ESETTING
D
EFAULT
P
ARAMETERS
From the
r.d.P
entry you will be able to reset the equipment's default parameters (refer to the
Default Parameters
Table
in
Annex E
). If you chose to reset the initial values, you will go back to the initial display. See Fig. 18
Once you confirm with
YES
, you cannot go back.
Fig. 18- Default parameters reset
3.3.8
S
ETTINGS
M
ENU
From the
OPt
entry of the Programming Menu, via the
Enter
key, you can access the
Settings Menu
From the Settings Menu you can carry out the following operations (refer to
Figure 19
):
Set the password to access the Programming section,
PAS
: with
Enter
you can go to the
“000” selection
page,
with the
▲
and
▼ keys you can increase/decrease the value displayed and with
Enter
you can scroll
through the figure you intend to set. After choosing the new password, press
Enter
for 3 seconds to go back
to the
PAS
entry;
Enable the pump stop in the case of a
P.St
level alarm: to access and exit the submenu, use
Enter,
to
scroll through “
YES/no
” use the
▲
and
▼ keys;
