14
AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO, TEMECULA, CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
Quartz Sleeve
Lamp
Clip Connector
Clip Connector
NOTE:
Do not force the Lamp into the Quartz Sleeve.
INSTALLING THE LAMP
Flush
Installation
Clip Connector
(Female)
Clip Connector
(Male)
2. CONNECT THE LAMP:
Plug the Lamp into each of the
Clip Connectors located at the end of the Harness.
Make sure the Lamp is plugged in all the way and flush with
each of the Clip Connectors.
WARNING: Be careful when installing the lamp. If the lamp is not plugged in all the way this
may cause damage to the unit and is not covered under warranty, nor is any other damage
caused by improper installation.
1. INSTALLING THE LAMP:
Extend Lamp Wires and
insert into Quartz Sleeve. Position Lamp so that the Clip
Connectors are visible on both ends of the unit.
NOTE:
If you touch the lamp use denatured alcohol and a soft cloth to clean it. If you do
not clean the lamp the fingerprints will become etched into the glass which will diminish UV
Output and may cause premature lamp failure.
NOTE:
Lamps and Quartz Sleeves should be handled with care. Lamps and Quartz Sleeves
are not warranted against breakage and damage.
WARNING:
Do not install the lamp at an angle (even a slight angle); this may cause a U
shaped crack at the end of the quartz sleeve, or possible breakage of the lamp. If this should
happen, do not proceed with the installation. Purchase a new Quartz Sleeve or Lamp from
your dealer and refer to the proper installation instructions.
Содержание Viper SL 1200 Watt
Страница 31: ......
