WARNINGS & SAFETY PROCEDURES
•
A Ground Fault Current Interrupter (GFCI) outlet must be installed to protect your electric outlet and prevent any possible electric shock.
•
The connection to the branch circuit should be consistent with local and national wiring electrical codes.
•
To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating
current not exceeding 30mA.
•
Do not turn the Power Supply on, unless the pool cleaner is in the water.
•
Operating the cleaner out of water will immediately cause severe damage and will result in loss of warranty.
•
The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below.
•
If the cable is damaged, it must be replaced by the manufacturer’s authorized service agent or a qualified and trained person in order to avoid
hazards.
•
Allow the cleaner to remain in the pool for 20 minutes following the end of its cleaning cycle. This will allow the motors to cool adequately.
Following this period remove the cleaner from the pool - Do not leave the cleaner in the pool.
•
Always remember to turn the power supply “OFF” and unplug it from the power outlet before removing the cleaner from the pool.
•
Do not operate your machine while people swimming in the pool.
•
For use in swimming pools only
•
Before performing any troubleshooting maintenance procedures, your Cleaner should be disconnected from the Power Supply (transformer) and
the Power Supply should be unplugged from the electrical outlet to prevent the possibility of personal injury or damage to your Cleaner!
OPERATION AND STORAGE TEMPERATURES:
Please be sure to always keep temperatures in mind when storing or using your pool cleaner:
•
Proper Storage Temperature Ranges:
10ºC – 40ºC (50ºF – 104ºF)
. This will keep the motors, plastics and seals protected.
•
Minimum / Maximum Usage Temperature Ranges:
13°C to 35°C (55°F to 95°F)
.
•
Optimal Usage Temperature Ranges:
22°C and 32°C (72°F and 90°F)
USE OF THE CLEANER IN A VINYL LINER POOL:
Some vinyl liner patterns are specifically susceptible to rapid surface wear and pattern removal caused by objects coming into direct contact with
the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and automatic pool cleaners. Vinyl liner patterns can
be seriously scratched or abraded simply by rubbing the surface with a pool brush. Additionally, ink from the pattern can also rub off during the
installation process or when it comes into contact with objects in the pool. The manufacturer is not responsible for, and the Limited Warranty does
not cover, pattern removal, abrasion or markings on vinyl liners.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
12ft / 4m
Midpoint of the Long side of Pool
POWER SUPPLY
CLEANER
