12
www.AquaProducts.com/Service
Models with Two Position
Diagonal Locking Floating Handle
+ Full Length Wheel Tubes
Pattern Description:
Your cleaner runs this pattern in SETS of side to side “half laps”. Each
set consists of 7 “half” laps.
Set 1:
In the first 6 half laps your cleaner finds the wall, goes up the
wall for about 30 seconds, while at the waterline, moves laterally
and then reverses to travel to the opposite wall (A). The cleaner
goes up the opposing wall for about 30 seconds, moves laterally at
the waterline and reverses to travel back again (B).
On the 7th half lap, your cleaner climbs the wall, finds the waterline and
moves laterally across the waterline for several minutes (C).
Set 2:
In the next 6 half laps your cleaner finds the wall, goes up the
wall for about 30 seconds, moves laterally at the waterline and then
reverses to travel to the opposite wall (D). Your cleaner goes up the
wall for about about 30 seconds, moves laterally at the waterline
and reverses to travel back again (E).
On the 7th half lap, your cleaner climbs the wall, finds the waterline and
moves laterally across the waterline for approximately a shorter period
of time (F).
In the next two sets, the 7th half laps will vary by traveling for about 2
minutes laterally across the waterline. After which, your cleaner will
repeat the entire program again.
E
A
B
C
D
F
CLEANING PATTERNS
Depending on your cleaner type, you will notice a different cleaning pattern produced.
Please reference the illustrations according to your cleaner.
Pattern Description:
Your c
A.
leaner searches for the wall and climbs it.
Then spends a number of seconds moving across the waterline
B.
and then climbs down the wall.
Your Cleaner moves across the floor to about half the width of the
C.
pool and then reverses backwards for a few seconds. The cleaner
turns slightly and moves towards the wall again.
Your cleaner climbs the wall for a couple of seconds.
D.
Your cleaner reverses to move back across the floor to about
E.
half the width of the pool and then reverses backwards for a few
seconds. The cleaner turns slightly and moves towards the wall
again.
Your cleaner climbs the wall for a couple of seconds.
F.
Your cleaner moves across the floor to about half the width of the
G.
pool and then reverses backwards for a few seconds. The cleaner
turns slightly and moves towards the wall again.
Your cleaner climbs the wall for a couple of seconds.
H.
Your cleaner moves to the opposite wall to restart the full pattern.
I.
Models with Cable
Float or Cable Float
+ 3 Directional
Remote Control
B
A
C
D
E
F
H
I
G
*
*
*
Internal program has a preset number of seconds for climbing.
In deep ends, it may not reach the waterline.
*
Models with NO Floating Handle are designed to climb partially
– not to waterline.
NOTE: All models are equipped with a safety feature that automatically reverses your cleaner after a number of minutes should it not
encounter a wall and tilt to approximately 90º. This protects your cleaner should it encounter the underside of a ladder for example. Most
models have a safety shut-off timer that periodically shuts off the power to your cleaner for a few seconds to allow it to float down from
its position as an additional measure of protection against getting stuck.
NOTE: For cleaning with the 3 directional remote control,
your cleaner uses the Cable Float on the Floating Cable to
lift itself on one side, which will allow your cleaner to pivot
on the opposite side in order to turn.
NOTE: Remote Control guidance can override automatic
program.
Remote Control System
TURN